R&S ZNB - 6.14.3 Print Tab; 6.14.4 Printer Setup Dialog

GUI Reference
R&S
®
ZNB/ZNBT
625User Manual 1173.9163.02 ─ 55
6.14.3 Print Tab
The buttons on the "Print" tab allow you to send the diagrams of the active setup to an
external printer, to a file or to the clipboard. Content and layout can be defined in the
Printer Setup Dialog.
Print
Prints the diagrams using the current content, printer and page settings (see Chap-
ter 6.14.4, "Printer Setup Dialog", on page 625).
Remote command:
The HCOPy... commands provide the printer settings; see Chapter 8.3.7, "HCOPy
Commands", on page 1051.
HCOPy[:IMMediate] initiates printing.
Print...
Opens a dialog that allows to define the content, printer and page settings (see Chap-
ter 6.14.4, "Printer Setup Dialog", on page 625).
To File...
Opens the "Save Image" dialog that allows you to select an output format and to save
the diagram content to a file. See also "Save Dialog" on page 104.
Note that only the first page of the "Print" result is saved.
Remote command:
HCOPy:DESTination
To Clipboard
Copies the diagram content to the clipboard, from where you can paste it into another
application.
Note that only the first page of the "Print" result is copied to clipboard.
6.14.4 Printer Setup Dialog
The "Printer Setup" dialog specifies how the active recall set is printed. Printer options
are specified in three tabs. The lower part of the dialog shows a preview of the print.
Access: SYSTEM – [FILE] > "Print" > "Print..."
File Softtool