R&S ZNB - Page 1348

Command Reference
R&S
®
ZNB/ZNBT
1348User Manual 1173.9163.02 ─ 55
<Num> Number of trigger signal (1 or 2)
Parameters:
<MeasSequence> SWEep | SEGMent | POINt | PPOint
Triggered measurement sequence, PPOint denotes "partial
measurement"; see TRIGger<Ch>[:SEQuence]:LINK.
<Slope> POSitive | NEGative | HIGH | LOW
Trigger slope for the triggered measurement sequence:
POSitive | NEGative - rising or falling edge
HIGH | LOW - high or low level
Example: See TRIGger<Ch>[:SEQuence]:MULTiple:SOURce
Manual operation: See "... /Source/ ... " on page 409
TRIGger<Ch>[:SEQuence]:MULTiple:SOURce
<Sequence>[, <TrigSource>]
Selects the source of the trigger events the analyzer uses to start a measurement
sequence in multiple trigger mode (TRIGger<Ch>[:SEQuence]:SOURce MULTi
ple).
Suffix:
<Ch>
.
Channel number
Parameters:
<Sequence> SWEep | SEGMent | POINt | PPOint
Triggered measurement sequence
PPOint denotes "partial measurement"; see TRIGger<Ch>[:
SEQuence]:LINK.
<TrigSource> IMMediate | EXT1 | EXT2 | E1A2 | E1O2 | MANual
Trigger source for the triggered measurement sequence
IMMediate
Free run measurement (untriggered)
EXT1
Trigger event at EXT TRIG IN or Pin 2 of USER PORT
EXT2
Trigger event at pin 25 of USER PORT.
E1A2
Trigger events at EXT1 AND EXT2
E1O2
Trigger event at EXT1 OR EXT2
MANual
Trigger event generated by pressing the "Manual Trigger" soft-
key
SCPI Command Reference