R&S ZNB - Page 880

Command Reference
R&S
®
ZNB/ZNBT
880User Manual 1173.9163.02 ─ 55
Mode Find...
MAXimum Absolute maximum in the search range (see CALCulate<Chn>:MARKer<Mk>:
FUNCtion:DOMain:USER[:RANGe] )
MINimum Absolute maximum in the search range
RPEak Next valid peak to the right of the current marker position
LPEak Next valid peak to the left
NPEak Next highest or lowest value among the valid peaks (next peak)
TARGet Target value (see CALCulate<Chn>:MARKer<Mk>:TARGet)
RTARget Next target value to the right of the current marker position
LTARget Next target value to the left
BFILter Bandfilter search. The results are queried using CALCulate<Chn>:MARKer<Mk>:
BWIDth.
MMAXimum or
MMINimum
Multiple peak search
SPRogress Sweep progress
CALCulate<Chn>:MARKer<Mk>:FUNCtion:RESult?
Returns the result (stimulus and response value) of a search started by means of
CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute. The search must be execu-
ted before the command is enabled.
Suffix:
<Chn>
.
Channel number used to identify the active trace
<Mk> This numeric suffix is ignored and may be set to any value.
Example: See CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute
Usage: Query only
Manual operation: See "Max / Min" on page 365
CALCulate<Chn>:MARKer<Mk>:FUNCtion:SPAN
Sets the sweep span of the sweep range equal to the absolute value of the first coordi-
nate of the active delta marker <Mk> on trace no. <Chn>.
Suffix:
<Chn>
.
Channel number used to identify the active trace
<Mk> Marker number.
SCPI Command Reference