REPLACEMENT AND ADJUSTMENT
SM 7 B830
Finisher
B830
1.2.3 ALIGNMENT BRUSH ROLLER
1. Open the front door and pull out the staple unit.
2. Remove the rear cover.
3. Remove the main board bracket and all connectors ( x 8). (1.4.6)
4. Remove the screw [A] and tension spring [B] for the tension bracket [C], and
release the tension of the timing belt.
5. Remove the pulley [D] and bearing [E].
6. Remove the inner cover [F] ( x 1).
7. Open the guide [G], then remove the alignment brush roller assembly [H].
8. Remove the alignment brush roller [I] ( x2, Bearing x 1 front/back, x1).
B830R507.WMF
B830R907.WMF
[A]
[B]
[C]
[D]
[F]
[G]
[H]
[I]
[E]
To Next Page
Loading...
