6.6 SERVICE
• Should your StreamPunch require service contact your local authorized service representative.
• There are NO user-serviceable parts inside the machine. To avoid potential personal injury
and/or property damage, DO NOT REMOVE THE MACHINE’S COVER.
• It is recommended that your StreamPunch receives preventative maintenance every 6 months or
sooner depending on usage.
6.7 PROBLEM SOLVING, OPERATOR LEVEL STREAMPUNCH
Problem Probable Cause
No power, won’t punch Power cord not attached to back of machine or not
properly plugged into the wall
Power On/Off Switch not activated
Die Set will not come out using a
moderate pull
The Die Set is in partial cycle. Turn the Die Set knob to
the HOME position. The Die Set should now slide out
easily.
Also see PAPER JAMS.
To Next Page
Loading...
