REPLACEMENT AND ADJUSTMENT
SM 23 B835
Cover
Interposer
Tray
B835
1.7.3 FEED BELT
• Feed belt unit (1.7.2)
[A]: Pick-up roller unit.
• Pull the unit away from the bushings in the direction of the arrow.
[B]: Feed belt holder
• Hold the feed belt holder by the sides, then lift up to separate from the
holder.
• Pull slowly to avoid losing the springs.
[C]: Feed belt.
Re-assembly
1. Position the pick-up roller unit [A] and feed belt holder [B] as shown above.
2. On the rear side, slide out the bushing, and rotate guide plate [D] until its
stepped side attaches at [E] as shown above, then snap the guide plate on.
3. On the front side, rotate guide plate [F] until its flat side is parallel with [D], then
snap it on. Viewed from the bottom, the plates must be aligned.
B835R103.WMF
B835R104.WMF
[A]
[B]
[D]
[E]
[C]
[F]
To Next Page
Loading...
