Ricoh B234 - Connecting the Finisher B830

Finisher SR5000 (B830)
SM 1-103 B234/B235/B236/D101/D102/D103
Installation
Connecting the Finisher B830
1. Open the front door of the finisher.
2. Pull out the locking lever [A] ( x1).
3. Align the finisher [B] with the joint brackets [C], then slowly push the finisher
onto the brackets.
4. Connect the finisher cable [D] to the copier
5. Push in the locking lever.
6. Check that the top edges of the finisher are parallel with edges of the finisher
(or copier) to the right.
7. Fasten the locking lever [A] ( x 1)
8. Close the front door.
9. Set the leveling shoes [E] (x4) under the feet.
10. Turn the nuts to adjust the height of the finisher until it is level.
B830I202.WMF
B830I206.WMF
[E]
[A]
[B]
[D]
[C]