Ricoh B234 - Copy Image Adjustment: Printing;Scanning; Printing; Registration - Leading Edge

COPY IMAGE ADJUSTMENT: PRINTING/SCANNING
3-184
3.18 COPY IMAGE ADJUSTMENT:
PRINTING/SCANNING
NOTE:
1) You need to perform these adjustment(s) after replacing any of the
following parts:
• Scanner Wires
• Lens Block
• Scanner Motor
• Polygon Mirror Motor
• Paper Side Fences
• Memory All Clear
2) For more details about accessing SP modes, refer to section 4.
3.18.1 PRINTING
NOTE:
1) Make sure the paper is installed correctly in each paper tray before you
start these adjustments.
2) Use the Trimming Area Pattern (SP2902 003, No. 27) to print the test
pattern for the following procedures.
3) Set SP2902 003 to 0 again after completing these printing adjustments.
Registration – Leading Edge
1. Check the leading edge registration using the Trimming Area Pattern, and
adjust it using SP1001 if necessary. The specification is: 0 ±3 mm.