Ricoh B234 - Sp4-Nnn Scanner

MAIN SERVICE PROGRAM MODE TABLES
B234/B235/B236/D101/D102/D103 5-40 SM
SP4-nnn Scanner
4008 Scanner Sub Scan Magnification
Adjusts the magnification in the sub scan direction for scanning. If this value is
changed, the scanner motor speed is changed. (3-18)
[-0.9~+0.9 / 0 / 0.1 percent]
Use the “ • / *key to enter the minus ( –) before entering the value.
Setting a lower value reduces the motor speed and lengthens the image in the sub
scan direction (paper direction). Setting a larger value increases the motor speed and
shortens the image in the sub scan direction.
4010 Scanner Leading Edge Registration
Adjusts the leading edge registration for scanning. (3-18)
[-9.0~+9.0 / 0 / 0.1 mm]
Use the “ • / *key to enter the minus ( –) before entering the value.
A minus setting moves in the direction of the leading edge. A larger value shifts the
image away from the leading edge, and a smaller value shifts the image toward the
leading edge.
4011 Scanner Side-to-Side Registration
Adjusts the side-to-side registration for scanning. (3-18)
[-3.0~+3.0 / 0 / 0.1 mm]
(–): The image disappears at the left side.
(+): The image appears at the left side.
Use the “
• / *key to enter the minus ( –) before entering the value.
4012 Set Scale Mask
A
djusts the erase margin for scanning. The leading, trailing, right and left margins
can be set independently.
Do not adjust this unless the user wishes to have a scanner
margin that is greater than the printer margin.
[0~3.0 / 0.5 / 0.1 mm]
001
Sub:LEdge
Leading edge, sub scan direction
002
Sub:TEdge
Trailing edge, sub scan direction
003
Main:LEdge
Front, main scan direction
004
Main:TEdge
Back, main scan direction
4013 Scanner Free Run
001 Scanner Free Run: Lamp OFF
Allows scanner free running with exposure lamp
off.
002 Scanner Free Run: Lamp ON
Allows scanner free running with the exposure
lamp on.