Ricoh B234 - How to Adjust Skew, Side-To-Side Registration

Skew and Side-to-Side Adjustment
SM 1-115 B234/B235/B236/D101/D102/D103
Installation
1.13.2 HOW TO ADJUST SKEW, SIDE-TO-SIDE REGISTRATION
1. Do a copy job with shift mode selected for the finisher.
NOTE: Use A3 or DLT paper.
2. At the output slot of the 3000-sheet finisher B830 and B836, watch the edge of
the paper at the scale to see if it deviates more the ±2 mm from the center line.
• Watch the front scale for A3 paper
• Watch the rear scale for DLT paper
3. If the leading/trailing edges are exiting at different points, there is some skew.
If the deviation is within 2 mm, no adjustment is necessary.
-or-
If the deviation is more than 2 mm, do the skew adjustment (see below).
4. If the leading/trailing edges are exiting at the same point slightly left or right of
center, there is some deviation in the side-to-side registration.
If the deviation is within 2 mm, no adjustment is necessary.
-or-
If the deviation is more than 2 mm, do the side-to-side registration adjustment
(see below).