Main Service Program Mode Tables
SM 5-7 B234/B235/B236/D101/D102/D103
Service
Tables
5.2 MAIN SERVICE PROGRAM MODE TABLES
NOTE: The Service Program Mode is for use only by customer engineers so that they can
properly maintain product quality. If this mode is used by anyone other than a customer
engineer for any reason, data might be deleted or settings might be changed. In such a
case image quality can no longer be guaranteed.
Service Table Key
Notation What it means
[range / default /
step]
[–9~+9 / +3.0 / 0.1 mm]
The default setting +3.0 can be adjusted in 0.1mm steps in the range
±9.
Italics Comments added for reference.
DFU Denotes “Design or Factory Use”. Do not change this value.
Japan only The feature or item is for Japan only. Do not change this value.
SEF Short Edge Feed
LEF Long Edge Feed
NIA No Information Available
User SP
This SP is part of the user/super user SP mode.
Super User Only
This denotes that the SP will be visible only to super users who have
opened the Super User Program Mode with their access code. These
SP codes are not available to users who display the SP codes by
touching the [User Program] button. All the SP codes described below
are available to super users.
To Next Page
Loading...
