CONTROLLER BOARDS, HDD
3-174
3.15.7 HARD DISKS
NOTE: The controller recognizes both disks as one disk unit. Both disks must
always be replaced together, or there will be errors.
1. Remove the controller box cover. (3.15.1)
2. HDD bracket [A] ( x 5, x 4).
3. Hard disks [B] ( x 8).
4. If you intend to re-install the same disks in the machine, confirm the correct
connections before disconnecting. After the disks have been formatted, they
are not identical, and each disk must be connected to the correct connector.
5. Install the new disks.
NOTE: If the disks are new and unformatted, they are both identical, and can
be connected in either position.
6. Turn the main switch on and execute 5832 001 (HDD Formatting – All) to
format the new disks.
7. Install the stamp data using SP5853. (”Stamp Data Installation”, 5. Service
Tables.)
8. Switch the machine off and on to enable the fixed stamps for use.
B234R160.WMF
B234R891.WMFMF
[A]
[B]
To Next Page
Loading...
