TONER SUPPLY AND RECYCLING
SM 6-101 B234/B235/B236/D101/D102/D103
Detailed
Descriptions
Toner Bottle Sensors
When a toner bottle is placed in the toner bank, the toner bottle pushes the lock
arm [A] down. Then the lock arm catches the toner bottle and also pushes down
lever [B]. This causes toner bottle sensor [C] to detect that a bottle has been
installed (the actuator leaves the toner bottle sensor while the bottle is being
inserted in the holder).
When replacing a toner bottle, push the toner bottle release lever [D] to release the
lock mechanism. While a toner bottle is supplying toner, the toner bottle opening
rod is pulled to the rear and the lock plate [E] is lowered by the link [F] so that the
toner bottle release lever cannot be pushed. Therefore, the toner bottle that is
supplying toner is always locked in place, and the user cannot pull out the bottle
until it is empty.
B234D994.WMF
B234D947.WMF
B234D948.WMF
[A]
[D]
[E]
[F]
[C]
[B]
To Next Page
Loading...
