TRANSFER BELT UNIT
SM 3-87 B234/B235/B236/D101/D102/D103
Replacement
Adjustment
3.9.3 TRANSFER BELT/BIAS ROLLER CLEANING BLADE
• Remove the transfer belt unit. (3.9.1)
1. Transfer belt /biss roller cleaning blade [A] ( x 2).
2. Clean the cleaning bias roller [B].
NOTE: Before vacuuming, remove the power pack connectors , to protect
the transfer power pack from static electricity.
3. Install the new cleaning blade.
NOTE: Never touch the edge of the cleaning blade. If the setting powder on the
blade edge is accidentally removed at some point, apply setting powder
or toner at that point before installation.
B234R108.WMF
[A]
[B]
To Next Page
Loading...
