Ricoh B234 - Bottom Plate Lift Wire

PAPER FEED
SM 3-99 B234/B235/B236/D101/D102/D103
Replacement
Adjustment
3.10.8 BOTTOM PLATE LIFT WIRE
NOTE: Before replacing the rear bottom plate lift wire, remove the front bottom
plate lift wire. The procedure for the two wires is the same.
Remove:
• Right tandem tray. (3.10.1)
• Tandem tray cover ( x 2). (3.10.7)
1. Sensor bracket [A] ( x 3) (Front Only).
2. Slightly lift the front bottom plate and unhook the wire stoppers [B], remove
stopper [C] and actuator [D].
3. Wire covers [E] ( x 1 each).
4. Bracket [F] ( x 1,  x 1, bushing x 1) (Front Only).
5. Gear [G] (Front Only).
6. Bottom plate lift wire [H].
B234R990.WMF
[A]
[B]
[C]
[D]
[E]
[F]
[G]
[H]