Multi Bypass Tray (B833)
SM 1-63 B234/B235/B236/D101/D102/D103
Installation
1.7.2 INSTALLATION
The Multi Bypass Tray B833 can be installed on either the LCIT RT5000 B832 or
the LCIT RT5010 B834.
CAUTION
Switch the machine off and unplug the machine before starting the
following procedure.
Before Installing the Multi Bypass Tray
If the LCT is connected to the machine, disconnect it.
To prevent damage to the connectors and ground wire, before pulling the LCIT
away from the mainframe:
• Pull the LCIT about 20 cm (8") away from the copier.
• Disconnect the connectors and the ground wire ( x 1)
• Pull the LCIT completely away from the machine.
Be sure to follow the correct tray installation procedure depending on which LCIT
will be installed.
LCIT Type Mounting Connection
• LCIT RT5000 B832
Do the procedure starting on page 1-64.
• LCIT RT5010 B834
Do the procedure starting on page 1-66.
Do the procedure starting on
page 1-68.
To Next Page
Loading...
