Ricoh B234 - Output Check; Main Machine Output Check: Sp

OUTPUT CHECK
B234/B235/B236/D101/D102/D103 5-178 SM
5.5 OUTPUT CHECK
5.5.1 MAIN MACHINE OUTPUT CHECK: SP5804
NOTE: Motors keep turning in this mode regardless of upper or lower limit sensor
signals. To prevent mechanical or electrical damage, do not keep an
electrical component on for a long time.
Main Machine Output Check (SP5-804)
1. Open SP mode 5-804.
2. Select the SP number that corresponds to the component you wish to check.
(Refer to the table on the next page.)
3. Press On then press Off to test the selected item.
No. Description No. Description
001 1st Pick-up SOL 043 Toner Collection Bottle Agitator Motor
002 2nd Pick-up SOL 044 Hopper Agitator Motor
003 3rd Pick-up SOL 045 Toner Cylinder Agitator Motor
004 LCT 1st Pick-up SOL 051 Guide Plate Solenoid
005 LCT 2nd Pick-up SOL 052 LCT Guide Plate Solenoid
006 LCT 3rd Pick-up SOL 053 Duplex Inverter Gate Solenoid
007 Bypass Pick-up SOL 054 Reverse Roller Solenoid
008 1st Separation Roller SOL 055 Inverter Guide Plate Solenoid
009 2nd Separation Roller SOL 056 Toner Recycling Shutter Solenoid
010 3rd Separation Roller SOL 057 2nd Cleaning Blade Solenoid
011 LCT 1st Separation Roller SOL 058 Transfer Belt Lift Solenoid]
012 LCT 2nd Separation Roller SOL 061 ID Sensor LED
013 LCT 3rd Separation Roller SOL 062 Quenching Lamp
014 Bypass Separation Roller SOL 063 Charge Corona
015 1st Tray Lift Motor 064 Grid Plate
016 2nd Tray Lift Motor 065 Development Bias
017 3rd Tray Lift Motor 066 Transfer Belt Bias
018 Rear Fence Drive Motor 067 Pre-Charge Grid
019 Tandem Tray Connect Solenoid 068 Charge Corona Grid
020 Front Side Fence Solenoid 069 ID Sensor
021 Rear Side Fence Solenoid 070 PTL
022 Left 1st Tray Lock Solenoid 081 Polygonal Motor Mirror Cooling Fan
031 Drum Motor 082 Exhaust Fan (Low)
032 Fusing/Exit Motor 083 Exhaust Fan (High)
033 Fusing Motor 084 Drum Cooling Fan (Low)
034 Web Motor 085 Drum Cooling Fan (High)
035 Development Motor 086 Paper Cooling Pipe Fan1
036 Upper Toner Bottle Motor 087 Paper Cooling Pipe Fan2
037 Lower Toner Bottle Motor 088 Steam Removal Fan (Low)
038 Toner Bank Motor 089 Steam Removal Fan (High)
039 Toner Supply Coil Clutch 090 Development Unit Cooling Fan1
040 Toner Suction Motor 091 Development Unit Cooling Fan2
041 Upper Bottle Cap Motor 092 Duplex Entrance Cooling Fan
042 Lower Bottle Cap Motor 093 Duplex Cooling Fan