Ricoh B234 - Front, Rear Scanner Drive Wires; Reinstallation

SCANNER UNIT
SM 3-39 B234/B235/B236/D101/D102/D103
Replacement
Adjustment
Front, Rear Scanner Drive Wires
1. Wire tension bracket [A] ( x 1).
2. Front scanner wire bracket [B].
3. Front scanner wire.
Reinstallation
1. Scanner wire pulley [C] ( x 1).
2. While making sure of the direction, place the beads on the middle of the wire on
the pulley openings. Then wind the wire (ball side) 3 times and the other side
(ring side) once as shown . Secure the pulley with tape to keep this condition.
3. Install the pulley on the scanner drive shaft ( x 1).
4. Wind the end of the wire with the ball as shown (,,).
5. Wind the end of the wire with the ring as shown (,,).
6. Install the tension spring on the tension bracket, and slightly tighten the tension
bracket ( x 1).
B234R013.WMF
B234R946.WMF
[A]

[B]
[C]





