INSTALLATION OF MFP CONTROLLER OPTIONS
B234/B235/B236/D101/D102/D103 1-142 SM
1.15.9 VM CARD TYPE C (B861)
Accessories
Description Q’ty
1. VM Card B861 SD Card.............................................................1
2. Decal.......................................................................................... 1
CAUTION: Unplug the main machine power cord before you do the following
procedure.
IMPORTANT: Do not remove the SD card from slot 3 after installing the platform.
Installation
1. With the power OFF and the machine
unplugged, remove the slot cover from
SD card slot 3 ( x 1).
2. Insert the VM-Card Type C [A] label
face to the rear of the machine. Then
push it slowly into slot 3 until you hear
a click.
3. Replace the sixth key-slot cover with
the “Other function” key (part number
B2381576).
4. Plug in and turn ON the main power
switch. The installation of the Java VM
platform will start automatically.
IMPORTANT: DO NOT turn the main power OFF. Also, do not open any of the
covers or do any machine operations. This will damage the SD card. A
damaged SD card cannot be repaired.
5. Wait five minutes, and then press
the “Other function” key. You will
hear two beeps.
If the screen does not change,
this means the installation is
not finished yet. Wait a few
more minutes and then press
the “Other function” key again.
When the installation is
finished, the following will be
displayed:
6. Set the heap size and stack size for the application. (In User Tools/Extended
Features setting, see the Administrator Tools tab.)
7. Install the application using the installation procedure provided with the
application.
B070I902.WMFMF
[A]
To Next Page
Loading...
