Around the Drum
SM 3-57 B234/B235/B236/D101/D102/D103
Replacement
Adjustment
3.7.7 ID SENSOR
1. Detach the front end of the shaft [A] ( x1) then lift the shaft out of the grooves.
2. Rotate the pick-off pawl [B] 45 degrees, then remove it.
3. Install a new pick-off pawl by rotating it onto the shaft.
4. Do not forget to hook the tension springs [C].
5. Follow the same procedure to replace the other pick-off pawl.
Important
• Do not allow the pawl springs to catch inside the pick-off pawl.
• After replacing the pick-off pawls, press down on each one to confirm that it
moves freely.
B234R205.WMF
B234R204.WMF
[A]
[B]
[C]
To Next Page
Loading...
