2. INSTALLATION
2.1 PRE-INSTALLATION
If a GBC StreamPunch II system is inline with a SR840 finisher, a Finisher punch must not be
installed. The Finisher punch is compatible with the SR 841.
INSTALLATION KIT CONTENTS – MT-C3 & VENUS
• E-PROM (new version for SR 841 Finisher) P/N C6847007
• Finisher Communication Cable Assembly P/N C6847002
• Finisher to Printer Cable (longer version) P/N C6847001
• GBC StreamPunch Interconnect Communication Cable (Gray) P/N VRC51278
INSTALLATION KIT CONTENTS – BC-3
• E-PROM for Venus only P/N C6847001
• Finisher to Printer Cable (long version) P/N
• GBC StreamPunch Interconnect Communication Cable (Gray) P/N
UNPACKING
• Inspect the outside of the package for shipping damage. If there is evidence of shipping
damage, contact the shipping carrier immediately.
• Remove the punch from its shipping carton.
• Inspect for any concealed damage to unit. If there is evidence of concealed shipping damage,
contact the shipping carrier immediately.
• Remove all shipping tape from doors and levers.
To Next Page
Loading...
