Ricoh B234 - Spxxx Feed

MAIN SERVICE PROGRAM MODE TABLES
B234/B235/B236/D101/D102/D103 5-154 SM
SPxxx Feed
1710
Shift Image With Feed
User SP
Adjusts the printing leading edge registration for feeding from the copier trays and the
duplex tray. Use the trimming area pattern printed with SP3740.
Press ./* to enter a minus sign (-) before you enter the value with number keys.
[-2 to +2/0/0.1 mm]
001 Front Side Image on front side of a copy.
002 Back Side Image on back side of a copy (duplex copied)
003 Front Side (Low Speed
Mode)
Image on back side of a copy (duplex copied in low
speed mode)
004 Back Side (Low Speed
Mode)
Image on front side of a copy (copied in low speed
mode)
1720
Shift Image Across Feed
User SP
Adjusts the printing side-to-side registration for sheets printed on paper from the feed
sources listed below. The adjustment is done with the trimming pattern printed with
SP3740.
Press ./* to enter a minus sign (-) before you enter the value with number keys.
001 Tray 1
002 Tray 2
003 Tray 3
004 Tray 4 LCT
005 Tray 5 LCT
006 Tray 6 LCT
007 Tray 7 Bypass
008 Duplex
[-2 to +2/0/0.1 mm]
1730
Adjust Paper Skew
Super User Only
User SP
Paper skew in the paper path is corrected by switching off the registration motor for
a very short time. The paper continues to feed and then straightens by buckling
against the stopper roller. This SP adjusts the amount of time the registration roller
motor remains off to create the buckle that straightens the paper.
• A positive value increases the amount of buckle for more correction. The
registration roller motor and roller remain idle for a longer time.
•
A
minus value decreases the amount of buckle for less correction. The registration
roller motor and roller remain idle for a shorter time.
• Press ./* to enter a minus sign (-) before you enter the value with number keys.
001 Tray 1,2,3
002 Tray 4,5,6 LCT
003 Duplex
004 Tray 7 (Bypass)
[0 to 3 / 0 / 1 mm]