Ricoh B234 - Disassembling the Hot Roller

FUSING UNIT
3-134
Disassembling the Hot Roller
1. Position the hot roller as shown.
2. Remove:
[A] C-ring
[B] Gear
[C] Bushing
[D] Bearing
3. Remove:
[E] C-ring
[F] Bushing
[G] Bearing
4. Remove the hot roller [H].
Reinstallation
When you install the new hot roller, make
sure that you install the correct type.
• The shape of the end  of the hot roller
for the B234/B235/D101/D102 is
different from the B236/D103 .
Lubricate the outer and inner surfaces of
bushings [C] and [F] with Barrierta –
JFE55/2.
B234R507B.WMF
B234R507E.WMF
[A]
[B]
[C]
[D]
[E]
[F]
[G]
[H]
B234/B235/D101/D102
B236/D103

