REPLACEMENT AND ADJUSTMENT
SM 1 B834
LCIT
B834
1. REPLACEMENT AND ADJUSTMENT
1.1 REMOVING TRAYS
CAUTION
• Tray 5 weighs 27 kg (60 lb.) empty. Trays 4 and 6 weigh 20 kg (44 lb.)
each empty.
• To prevent damage to the tray and personal injury, never attempt to lift a
tray alone or without attaching the carrying handles, especially if a tray
is loaded with paper.
• Two people on each side of the tray should lift the carrying handles
together to lift and move the tray.
• Never remove the tray if the LCT has not been docked to the copier.
Removing the tray while the LCT is standing alone can unbalance the
LCT and cause it to fall over.
Important: Only one set of carrying handles is attached to the side of Tray 5.
Follow the procedure below to attach and use these handles to move Tray 4, 5, or
6.
1. Pull the tray [A] out of the LCT until it stops.
2. Remove the screws from the right rail [B] ( x3)
3. Remove the screws from the left rail [D] ( x3)
NOTE: You do not need to remove screw for the stopper pin bracket at the
back of the left rail.
B834R108.WMF
To Next Page
Loading...
