DETAILS
SM 63 B830
Finisher
B830
3.12.2 JOGGER UNIT DRIVE
After the first sheet exits, the shift tray jogger motor [A] switches on and rotates the
jogger timing belt [B], gear [C] and jogger fence timing belt [D]. This closes the
jogger fences [E] against the sides of the first sheet to align it and stops. Next, the
motor reverses to open the fences for the next sheet. The jogger motor alternates
its direction of rotation to open and close the jogger fences. The timing is
prescribed by the width of the paper selected for the job.
At the end of the job, the actuator [F] activates the shift tray jogger HP sensor [G]
which shuts off the jogger motor and starts the jogger fence retraction motor [H].
The jogger fence retraction motor rotates the shaft which raises the jogger fences
and lowers the actuator [I] into the slot of the jogger fence retraction HP sensor [J].
The activated sensor turns off the jogger fence retraction motor and the jogger
fences remain at the raised position.
B830D002.WMF
[H]
[I]
[J]
[A]
[B]
[C]
[D]
[E]
[F]
[G]
To Next Page
Loading...
