Ricoh B234 - Green Belt Replacement, Paper Entrance Side

25
ACTION IN THE FIELD
Replace the Green Belt of the Belt Aligner Assembly using the following procedure.
PROCEDURE TO REPLACE ALIGNER BELTS
Replacement of the Green Belt from the Aligner, Paper Entrance Side.
Replacement of the Green Belt from the Aligner, Paper Exit Side.
4.5 GREEN BELT REPLACEMENT, PAPER ENTRANCE SIDE
The following step-by-step directions inform you how to remove and then assembly the components
necessary to access the Paper Entrance
Side Aligner Green Belt.
It will help you to reference your StreamPunch Service Manual part drawings as you follow this
process.
Special Tools Required:
• Twelve inch metal ruler or similar straight edge.
• Phillips Head Screw Driver 7” or less in total length.
• Alan wrenches (5/64” & 9/64”).
• Nut Driver (1/4” & 5/16”).
• Rare Earth Magnet Snake Neck (optional – good for retrieving any hardware that happens to fall in
hard to reach spots).
• Snap Ring pliers.
• E-Ring tool
NOTE: During assembly, be sure not to over tighten any of the mounting screws.
Step 1: Disconnect the StreamPunch from Power. Retain the power cord in your possession for
your safety.
Step 2: Disconnect the Communication Cable to the Finisher.
Step 3: Unlatch the GBC StreamPunch from both the Finisher and the Printer.
NOTE: You must first remove the screw that secures the latch in place (if so
equipped).
Step 4: Open the Front Door (A) of the StreamPunch.
Step 5: Remove the Paper Chip Tray (B), empty it and replace it. This is to prevent difficulty in
finding any small parts that you may drop into the chad.
BINDER SIDE
FINISHER SIDE
B
A