Punch UNIT PU5000 (B831)
SM 1-105 B234/B235/B236/D101/D102/D103
Installation
1.12.2 INSTALLATION
Important!
• This punch unit is for the B830 finisher only. It cannot be installed in the Booklet
Finisher BK5000 (B836).
• This punch unit cannot be used with the B236/D103 copier (135 ppm).
CAUTION
Switch the machine off and unplug the machine before starting the
following procedure.
1. If the finisher is connected to the machine, disconnect it.
2. Open the front door and remove the rear cover ( x 2).
3. Unpack the punch unit and remove the motor protector plate [A] ( x 4, Step
screw x1).
4. Remove the cam lock plate [B] ( x 1).
5. Remove the inner cover [C] ( x 3).
6. Behind the inner cover at [D] and [E], press the lock tab to the right to release
the inner cover from the frame.
7. Remove the plastic knockouts [F].
B831I102.WMF
B831I103.WMF
[A]
[B]
[C]
[D]
[F]
[E]
To Next Page
Loading...
