INSTALLATION OF MFP CONTROLLER OPTIONS
B234/B235/B236/D101/D102/D103 1-138 SM
Seal Check and Removal
CAUTION
TURN OFF THE MAIN POWER SWITCH AND DISCONNECT THE POWER SUPPLY CORD.
1. Check the two box seals [A] on the corners of the box.
• Make sure that the seals are attached at both corners.
• The surfaces of the tapes must be blank. If you see “VOID” on the tapes, do
not install the components in the box. Contact your sales division.
2. If the surfaces of the tapes do not show “VOID”, remove them from the corners
of the box.
3. After you remove each seal, the “VOID” marks [B] become visible. This
prevents them from being reattached to the box.
B735I901.WMF
B735I903.WMF
[B]
[A]
To Next Page
Loading...
