39
Now you need to run some paper and check for skew, at this point you can now use the three screws
to adjust skew if needed. After the adjustment is made re test with the three-hole die. If all is well re
test with the VeloBind die to make sure there are no deep punches.
Step 14: Back Gage Adjustment to eliminate Deep Punching
: Check for proper operation with
PB Die Set: In some cases, using a PB Die Set, you may have an occurrence of a
“Deep Punch” symptom. If this shows up during testing, loosen the three main screws
that secure the entire Back Gage Assembly, push the entire mechanism upward, taking
up all play, tighten the three screws securely. Test approximately 200 to 500 sheets of
paper through the PB die. Check for no deep punching and no paper jamming in the Die
Set area
4.9 TO CLEAR A PAPER JAM
To clear a jam, first press the stop button on the printer, then check the printer screen to see the area
of the jam.
If the jam is in the printer or finisher only, follow the information on the screen to clear the jam.
If the screen shows a jam in the punch, try to follow this sequence.
1. Open punch door.
2. Turn off the power
3. Turn punch knob J3 to home position.
4. Open top cover J1.
5. Open front paper door lever J2.
6. Open exit paper door lever J8.
7. Open bottom U-channel J7 by pressing in lever J6 and lower.
8. Clear paper from all these areas by turning knobs as shown.
9. When all the paper is cleared turn on power shut the door make sure the jam light is out if not go
back to step 1. And find the paper that is not clear.
10. When all the paper is cleared from the punch and the light is out follow the steps used above to
clear the printer and finisher.
11. Hit the punch green button and then the resume button on the printer, operation should start.
12. If by chance you do not hit the green button the punch will go into bypass mode at this time you
will have to hit the stop button on the printer hit the green button on the punch then the resume
button on the printer.
13. This is only my way to clear a jam after you become more familiar with the punch this procedure
can change to your own refinement.
To Next Page
Loading...
