INSTALLATION OF MFP CONTROLLER OPTIONS
B234/B235/B236/D101/D102/D103 1-128 SM
Merging Applications
Do this procedure to put more than one application on one SD card.
1. Turn off the copier.
2. Remove the SD card slot cover ( x1).
3. Put the Source SD card in Slot 3 (C3). This card contains the application that
you want to copy.
NOTE: The PS SD card cannot be the source card (it cannot be copied).
4. Make sure that the target SD write-protect switch is OFF.
5. Put the Target SD card in Slot 2 (C2). The application on the card in Slot 3
(C3) will be copied to this card.
6. Open the front door.
7. Turn the copier on.
8. Go into the SP mode and select SP5873 001.
9. Touch "Execute".
10. Read the instructions on the display and touch "Execute" to start copying.
11. When the display tells you copying is completed, touch "Exit".
12. Turn the copier off.
13. Remove the Source SD card from Slot 3 (C3). Keep the target SD card in Slot
2 (C2).
14. Turn the copier on.
15. Go into the User Tools mode and check that all the applications on the SD card
in Slot 2 are enabled:
User Tools> System Settings> Administrator Tools> Firmware Version
16. Turn the copier off again, then:
• Reattach the SD card slot cover.
• Attach the rear cover of the machine.
• Store the SD cards that were copied. (Pg.1-130)
Important!
• After an SD card has been copied, it cannot be used. However, it must be
stored in the machine to serve as proof of purchase by the customer.
• The original card can also be used to perform an undo procedure (SP 5873
002). Before you store an SD card, label it carefully so it can be identified
easily if you need to do the undo procedure (see the next page).
To Next Page
Loading...
