EasyManua.ls Logo

Ricoh B234 - Error Codes

Ricoh B234
1335 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SERVICE CALL CONDITIONS
B234/B235/B236/D101/D102/D103 4-98 SM
Monitor Error
SC817 D
This is a file detection and
electronic file signature check
error when the boot loader
attempts to read the self-
diagnostic module, system
kernel, or root system files from
the OS Flash ROM, or the items
on the SD card in the controller
slot are false or corrupted.
OS Flash ROM data defective; change
the controller firmware
SD card data defective; use another SD
card
Error Codes
Code Meaning
0x0000 0000 BIOS boot error
0x0000 0001 Primary boot start load error
0x0000 0002 Secondary boot load error (Boot3.Elf)
0x0000 0003 Self-diagnostic module error (Diag.Elf
0x0000 0004 Kernel start error (Netbsd)
0x0000 0005 Root file system file read error (Rootfs)
0xffff ffff Other error
Example: Data in the self-diagnostic module, system kernel, or root system files
are corrupted or do not exist in OS flash ROM or on the SD card
Files in the self-diagnostic module, kernel, or root file system on the SD card have
been falsified or altered
Before discarding the SD card, try to update the data on the card. If the error
occurs again, the card may be defective.
Be sure to use an SD card that contains the correct electronic signature.
Self-Diagnostic Error 7: Engine I/F ASIC
SC833
C
A read/write verify error done on the
resident RAM on the mother board (Engine
I/F board failed).
Replace RAM DIMM on the
mother board.
Replace mother board
NOTE: For more details about this SC code error, execute SP5990 to print an SMC
report so you can read the error code. The error code is not displayed on the
operation panel.
Self-Diagnostic Error: Memory/RAM/DIMM
SC834 D
An error occurred while the machine was
performing the write/verify check for the
optional RAM chip on the engine
motherboard.
The memory on the
motherboard is defective.
The motherboard itself is
defective.
IEEE 1394 I/F Error
SC851 D
Driver setting incorrect and
cannot be used by the 1394
I/F.
NIB (PHY), LINK module defective;
change the Interface Board
Controller board defective

Table of Contents

Other manuals for Ricoh B234

Related product manuals