COPIER (B234/B235/B236/D101/D102/D103)
SM 1-31 B234/B235/B236/D101/D102/D103
Installation
Connecting the Copier Tray Heaters
The machine comes from the factory with the tray heaters already installed but
disconnected. Tray heater connection is optional. The heaters should be connected
if the location has high humidity.
Consult with the customer before connecting the tray heaters.
Doing this procedure connects the following anti-condensation heaters inside the
copier at the following locations:
• One unit below the transfer unit
• Two units in the paper tray unit (if installed)
• One unit in the scanner unit (if installed)
• One unit in the LCT (if installed)
1. Switch off the main power switch and
disconnect the power cord from the power
source.
2. Open the PSU box ( x 2).
To set the connector
3. Connect the white connector [B] to CN602 on
the AC drive board [C].
NOTE:
• Connect the large connector clamped
beneath the board.
• This step is not required if the LCT anti-
condensation heater will be connected.
B234I901.WMFF
B234I391A.WMF
[B]
[C]
[A]
To Next Page
Loading...
