Ricoh B234 - Disabling the off Mode; Entering the off Mode; Off Mode

ENERGY Conservation MODES
B234/B235/B236/D101/D102/D103 6-186 SM
6.19.4 OFF MODE
Off mode is used only if no optional printer/scanner unit is installed.
Entering the off mode
The machine enters off mode when one of the following is done.
• The auto off timer runs out after the last job (User Tools – System Settings –
Timer Setting – Auto Off Timer: default setting is 60 min)
• The operation switch is pressed to turn the power off
What happens in the off mode
When the machine enters off mode, the fusing lamps and all dc supplies except
+5VE/12VE (+5V/12V for energy saver mode) turn off.
Returning to stand-by mode
The machine returns to stand-by mode when the main operation switch is pressed.
Operation
Switch
Energy
Saver LED
Fusing Temp.
Approx.
Recovery
Time
System
+5V
Note
Off Off
Room Temp.
(Fusing lamp off)
Depends on the
model and the
region: See
‘Energy Star’ in
the Specifications.
Off
Only +5VE
and +12VE
are supplied to
the Controller,
MB, HDD.
Disabling the off mode
If the user wishes to disable the off mode, use the following user tool: User Tools –
System Settings – Administrator Tools – AOF (change the setting to ‘OFF’).