PAPER FEED
SM 3-119 B234/B235/B236/D101/D102/D103
Replacement
Adjustment
3.10.20 TANDEM TRAY SIDE REGISTRATION
Normally the side registration of the image can be adjusted in the SP mode.
If the punch hole positions are not aligned from a particular feed station, however,
you can manually adjust the side registration by changing the tray cover position
for that tray, and then adjust the side registration of the image (See 3,10,18)
1. Pull out the tray and remove the right inner cover [A].
2. Loosen the screws and adjust the position of the plate [B].
Adjustment range: 0 ± 2.0 mm adjustment step: 1.0 mm/step
B234R996.WMF
[A]
[B]
To Next Page
Loading...
