Installation of MFP controller Options
SM 1-133 B234/B235/B236/D101/D102/D103
Installation
Installation
CAUTION
Before you begin this procedure, switch the machine off and disconnect
the power plug from the power source.
1. Switch the machine off.
2. Remove the controller box
cover ( x 9).
3. Insert the 256 MB memory
DIMM [A].
4. Insert the 128 MB memory
DIMMs [B] and [C] (x2) in
the mother board.
5. Re-attach the controller box
cover.
6. Hold the SD Card [D] with its label
facing shown, then push it into Slot C2.
Important
• Pushing in the SD Card releases it
for removal.
• Make sure the SD Card is inserted
and locked in place. If it is partially
out of the slot, push it in gently until
it locks in place.
• Only one slot (C2) is available for
applications on SD cards. If more
than one application will be used, the
applications must be merged onto
one SD card with SP5873 001.
(1.15.2)
B840I100.WMF
B840I201.WMF
[D]
[A]
[B]
[C]
To Next Page
Loading...
