Ricoh B234 - 2 Nd Fold Adjustment

REPLACEMENT AND ADJUSTMENT
B660 16 SM
2nd Fold Adjustment
1. Print one A3 copy and send it through the Z-
fold unit.
2. Open the folded sheet at the 1st fold  then
lay it down flat.
3. Stand the sheet on its end so the edge  is
up and the crease of the 1st fold is facing
out.
4. Open the left door and locate the screw that
adjusts the 2nd fold (see previous page).
5. Use a plus screwdriver to turn the screw [A]
to the left to loosen the nut.
• If the corner is over the right edge, turn
the screw to the right.
• If the corner is over the left edge, turn the
screw to the left.
NOTE:
• The illustration shows the corner over the
right edge.
• You can see the pointer [B] change
position on the notches of the adjustment
scale as you turn the screw.
6. Close the Z-Fold unit.
7. Do another test print.
8. If the 1st fold is still misaligned, repeat
this procedure until the alignment is
correct.
9. After the adjustment is completed, use
a screw driver to hold the screw in
position, then retighten the nut you
loosened in Step 2. Do not turn the
screw.
1
2
3
3
B660R225.WMF
B660R230.BMP
[A]
[B]