LCIT RT5000 (B832)
B234/B235/B236/D101/D102/D103 1-50 SM
Procedure 2
CIS Image Position Adjustment: Normal Paper (LCIT)
13. Push [User Tools]> [Adjust Settings for Operators].
14. Do SP1911 for Trays 4, 5, 6, and 7, and set the value for each tray to "0" (OFF).
15. Enter the SP Mode menu.
16. Adjust the image positions in the main scan direction.
• Do SP2902 003, select Pattern 27, then print the trimming pattern.
• Do SP1002 and adjust the image position in the main scan direction for
Trays 4, 5, 6, and 7.
• Print the trimming pattern from each tray of the LCT and from the bypass
tray (if installed).
• To do this, touch "Copy Window" in the SP display, select a tray, then push
[Start].
• The distance of the test pattern line from the paper edge for each tray must
be 2 mm. If it is not 2 mm, adjust with SP1002 004 to 007, depending on
which tray is not within the specified 2 mm.
17. Print the trimming pattern (pattern27) one more time.
18. Do SP1912 002 (CIS Image Position Adjustment: Normal Paper). This sets the
CIS for operation with standard copy paper.
19. Exit the SP mode. Push [User Tools]> [Adjust Settings for Operators].
20. Do SP1911 again (CIS Image Position Adjustment: Feed Setting) and reset the
values for Trays 4, 5, 6, and 7 to "1" (ON).
B234I999.WMF
2 mm
To Next Page
Loading...
