REPLACEMENT AND ADJUSTMENT
SM 7 B834
LCIT
B834
1.5.2 FEED MOTORS/GRIP MOTORS
Each paper feed unit has a pick-up feed motor and a grip motor . The removal
procedure is the same for each feed tray.
1. Remove the left rear cover (1.2)
2. Use a small screwdriver to turn the shaft [A] so the pin can slip out of the
keyhole.
Remove:
[B] Motor unit ( x4, = x2, x2)
[C] Springs (x2). First, loosen the screws (x2) , .
[D] Paper feed motor ( x2, Timing belt x1)
[E] Grip motor ( x2, Timing belt x1)
Reinstallation
• Attach the tension spring, then tighten the screws to tighten the belts.
B834R109B.WMF
B834R109C.WMF
[A]
[B]
[C]
[D]
[E]
To Next Page
Loading...
