Ricoh B234 - 1 St Fold Adjustment; Z-Fold Adjustment Procedure

REPLACEMENT AND ADJUSTMENT
SM 15 B660
Z-Folding Unit
B660
1.13.3 Z-FOLD ADJUSTMENT PROCEDURE
1st Fold Adjustment
1. Print one A3 copy and send it through
the Z-fold unit.
2. Open the 2nd fold .
3. Turn the paper over so the edge  is
aligned with the crease of the 2nd fold.
4. Open the right door and locate the
screw that adjusts the 1st fold (see
previous page).
5. Use a plus screwdriver to turn the
screw [A] to the left to loosen the nut.
• If the corner is over the right edge,
turn the screw to the right.
• If the corner is over the left edge,
turn the screw to the left.
NOTE:
• The illustration above shows the
corner over the right edge.
• You can see the pointer [B] change
position on the notches of the
adjustment scale as you turn the
screw.
6. Close the Z-Fold unit.
7. Do another test print.
8. If the 1st fold is still misaligned, repeat
this procedure until the alignment is
correct.
9. After the adjustment is completed, use
a screw driver to hold the screw in
position, then retighten the nut you
loosened in Step 2. Do not turn the
screw.
1
2
1
3
3
B660R215.WMF
B660R220.BMP
[A]
[B]