COVER INTERPOSER TRAY CI5000 (B835)
B234/B235/B236/D101/D102/D103 1-76 SM
Docking the Next Peripheral Device
The next peripheral device to the left of the cover interposer tray must be installed
before you can mount the tray unit on top of the transport unit of the cover
interposer tray.
• The tray unit of the cover interposer tray is supported by the top of the next
peripheral device in line to the left, as well as the transport unit of the cover
interposer.
• The next peripheral device to the left of the cover interposer must be set up and
docked to the cover interposer before the transport unit of the cover interposer
can be mounted.
The table below shows which section to see for instructions on connecting the
cover interposer.
Connect Cover Interposer
Z-Folding Unit B660 (1.9)
Booklet Finisher B836 (1.10)
Finisher B830 (1.11)
CAUTION
• Never attempt to mount the cover interposer tray until the next device in
line (Z-Folding Unit B660, Booklet Finisher BK5000 B836, or Finisher
SR5000 B830) has been docked to the transport unit (base) of the cover
interposer tray.
• To prevent bending the frame of the tray unit and damaging its
alignment, always remove the tray unit from the cover interposer tray
transport unit: 1) before disconnecting either the cover interposer tray or
the next peripheral device to the left, or 2) before doing any maintenance
on either the cover interposer tray or the next peripheral device to the
left.
To Next Page
Loading...
