4. ADJUSTMENT AND SPECIAL PROCEDURES
4.1 TOOL RECOMMENDATIONS
What you need to service the GBC StreamPunch:
1. Standard Measure Tools (English as opposed to metric)
a. Open End Ignition Wrench – ¼” (required only for Chad Kit installation)
b. Nut Driver, 5/16” (optional use Phillips head)
c. Nut Driver, 1/4” (optional use Phillips head)
d. Allen Wrench, 3/32” (comes with Chad Control Kit)
e. Allen Wrench, 5/64”
f. Allen Wrench, 9/64”
2. Other recommended tools
a. Needle Nose Pliers (Side Cutters)
b. E-Prom Extractor Tool – Order under Ricoh P/N VRC11186 (Also used for Plockmatic) or can
be purchased from the following supplier:
SupplierDigi-Key.com
Digi-Key Part Number: K293-ND
Manufacturer Part Number: EX-5
Description: TOOL EXTRACTOR IC PLCC UNIVERSAL
c. Wire Cutters
d. Screw Driver, Phillips Head
e. Screw Driver, Flat Head, Small
3. Supply of Wire Tie Wraps
NOTE: A nut driver head of ¼” is the most common size for the barrel of a Magnetic or
interchangeable tip screwdriver.
4.2 DIE SET POSITION CRADLE ADJUSTMENT, CENTERING
PUNCHED HOLES
The die set position cradle is set in the factory; however, because of the punched-hole spacing on the
PB die sets, there is a minimal amount of paper on each edge of the punched paper. The die set
position cradle may have to be fine adjusted to center the punched-hole pattern in the paper.
Listed below are the step-by-step instructions to adjust the die set to the proper position:
• The punched-hole alignment must be checked on a piece of punched paper. Fold the punched
sheet of paper in half and the punched-holes should be aligned. If the punched-holes are not
aligned, then the die set cradle must be adjusted to align the punched holes.
NOTE: The paper path is always constant, if the holes are not centered, you must adjust the
die set cradle.
To Next Page
Loading...
