AROUND THE DRUM
3-48
Re-installing the Drum
Important
• Apply a sufficient amount of setting powder to the drum as far as the edges.
• You need to only apply the powder where the drum will be exposed to the
cleaning blades.
• Use clean toner if drum setting powder is not available.
• Never touch the surface of the drum with bare hands.
1. Set the drum in the PCU.
2. Cover the area of the drum [A] that will be under the cleaning blades with drum
setting powder as shown above.
3. Do SP3905 (OPC drum initial setting) and SP2962 (Auto process control
execution) for the new drum.
B234R977.WMF
[A]
To Next Page
Loading...
