Ricoh B234 - Transfer Belt Unit; Transfer Belt Unit Removal

TRANSFER BELT UNIT
SM 3-83 B234/B235/B236/D101/D102/D103
Replacement
Adjustment
3.9 TRANSFER BELT UNIT
3.9.1 TRANSFER BELT UNIT REMOVAL
1. Turn off the main switch.
2. Remove the inner cover. (3.3.1)
3. Remove the transfer belt unit cover [A] ( x 2).
4. Remove the transfer belt unit holder [B] ( x 1).
5. Connector [C] ( x 1).
6. While turning the lever [D] counterclockwise, take out the transfer belt unit.
NOTE
1) Never touch the transfer belt with bare hands.
2) Work carefully to avoid scratching the drum with the transfer belt unit.
Reassembly:
1. Rotate the lever [D] fully counterclockwise, then install the transfer belt unit.
2. Insert the gear [E] into the opening [F] in the rear frame.
3. Place the slot [G] in the transfer belt unit on the rail.
4. Connect the connector [C] ( x 1).
B234R401.WMF
B234R402.WMF
[A]
[B]
[C]
[D]
[E]
[F]
[G]