Main Service Program Mode Tables
SM 5-155 B234/B235/B236/D101/D102/D103
Service
Tables
1740
Set Fusing Temperature
Super User Only
User SP
This SP allows you to raise or lower the fusing temperature. Three fusing lamps
inside the hollow hot roller generate enough heat to fuse toner when each sheet
passes between the hot roller above and pressure roller below. The copier will not
start copying unit the hot roller reaches the temperature prescribed for the job.
[0 to 2/0/1 step]
0: Medium
1: Low
2: High
• Raise the temperature setting if you see loose toner, indicating that the toner has
not fused completely with the surface of the paper.
• Lower the temperature setting if the paper is excessively curled after it leaves the
machine.
1750
Unit Initialization
Super User Only
User SP
After you replace the fusing unit, do this SP and press [Execute].
Use this SP code to initialize the control mechanism of the web cleaner inside the
fusing unit.
The web cleaner (a web supply roller and a take-up roller) is mounted above and
slightly to the right of the hot roller. The roll (24 m long), a soft web material
saturated with silicone oil, touches the surface of the hot roller as it rotates. The soft,
lubricating surface of the web cleans the surface of the hot roller by scavenging
toner, paper dust, and other foreign matter that collects on the hot roller.
1908
Double-Feed Detection
Super User Only
This SP code switches double-feed detection off/on for the trays listed below.
[0~1/1/1]
1: On, 0: Off
001 Tray 1
002 Tray 2
003 Tray 3
004 Tray 4 (LCT Tray 1)
005 Tray 5 (LCT Tray 2)
006 Tray 6 (LCT Tray 3)
007 Tray 7 (Bypass)
008 After Double-Feed Detection This SP setting determines what happens when
a double-feed is detected.
[0~1/0/1]
0: Sends the double-feed sheet to the upper tray.
1: Signals a jam alert.
To Next Page
Loading...
