SERVICE TABLES
SM 41 B830
Finisher
B830
2. SERVICE TABLES
For details about 3000-Sheet Finisher B830 SP codes, please refer to “5. Service
Tables” in the main machine service manual.
2.1 DIP SWITCHES
DIP SW100
This DIP SW100 settings are for designer and factory use only. Do not change
them.
DIP SW 101: 1 to 4
DPS100
1 2 3 4
Description
0 0 0 0 Default
1 0 0 0 Free run: 135 ppm (649 mm/s) A4 LEF, 5 sheets
0 1 0 0
Proof tray free run for durability testing: proof tray + punch +
junction gate operation + proof tray output.:
0 0 1 0
Shift free run: Shift mode simulation 136 ppm (649 mm/s) A4
SEF, 5 sheets, continuous punching 110 ppm (515mm/s)
0 0 0 1
Sensor check before shipping, lowering the tray before shipping.
DFU. Do not change.
2.2 TEST POINTS
100 to 110
No. Label Monitored Signal Comment
TP100 (5V) +5 V
TP101 (GND) Ground
TP102 (RXD) RXD
TP103 (TXD) TXD
Used for sensor point testing,
lowering the tray to shipping
position. DFU.
2.3 FUSES
No. Function
FU100 Protects 24 V.
To Next Page
Loading...
