REPLACEMENT AND ADJUSTMENT
B834 20 SM
14. Adjust the image positions in the main scan direction.
• Do SP2902 003, select Pattern 27, then print the trimming pattern.
• Do SP1002 and adjust the image position in the main scan direction for
Trays 4, 5, 6, and 7.
• Print the trimming pattern from each tray of the LCT and from the bypass
tray (if installed).
• To do this, touch "Copy Window" in the SP display, select a tray, then push
[Start].
• The distance of the test pattern line from the paper edge for each tray must
be 2 mm. If it is not 2 mm, adjust with SP1002 004 to 007, depending on
which tray is not within the specified 2 mm.
15. Do SP1912 002 (CIS Image Position Adjustment: Normal Paper). This sets the
CIS for operation with standard copy paper.
16. Exit the SP mode.
17. Push [User Tools]> [Adjust Settings for Operators].
18. Once again, do SP1911 (CIS Image Position Adjustment: Feed Setting) and
reset the values for Trays 4, 5, 6, and 7 to "1" (ON).
B834R905.WMF
2 mm
To Next Page
Loading...
