9
PAPER ENTRANCE SIDE (PRINTER SIDE)
Apply one of the two remaining long strips to the
right side of the printer side of the StreamPunch
as shown.
Apply the last remaining short strip to the top
cover edge of the printer side of the StreamPunch
as shown.
Apply the last remaining long strip to the left side
of the printer side of the StreamPunch as shown.
FINISHER PREPARATION – BC-3
1. Attach connection to Finisher board
2. Replace Finisher to Printer cable
3. Attach 2 cables together
4. Connect Finisher to Printer
5. Connect Finisher to StreamPunch
To Next Page
Loading...
