K
G
I
J
H
FRONT DOOR SIDE
L
Step 12: To remove the Drive Side, Paper Entrance Guide Aligner Assembly (L), which is the
large sheet metal Assembly that actually, containers the Green Belt and Aligner.
A. Remove the “6” Screws that secure the face of this Assembly.
B. Remove the “2” screws that secure this Assembly from the Side Frame.
C. Pull and walk the entire sheet metal assembly of the Paper Guide Aligner Assembly
up and outward. You can grab the Assembly at the Roller cut out with your fingers.
IMPORTANT: As you do this, disconnect the Sensor harness behind the Assembly as soon as
you are able to reach it.
Step 13: Before you remove the Green Belt Aligner Roller Assembly from the sheet metal
paper guide, observe the perfectly flush surfaces of the Green Belt Aligner Roller
Assembly to the sheet metal surface of the Rear, Drive Side, Paper Guide Aligner
Assembly. Hold a straight edge like a 12”metal ruler across the surface of the sheet
metal face and the metal (w/o a belt) Green Belt Aligner Roller itself. Note that the
two metal surfaces are flush.
Step 14: Remove the Green Belt Aligner Roller Assembly by removing the “4” screws (S).
IMPORTANT: Leave the Flex Shaft (FS) attached.
Step 15: Stretch the new Belt (B) onto the Aligner Roller Assembly, green side out. Rotate the
Shaft (S) to confirm that the belt tracks properly.
To Next Page
Loading...
