Main Service Program Mode Tables
SM 5-115 B234/B235/B236/D101/D102/D103
Service
Tables
SC/Jam Counter Reset
7807
Resets the SC and jam counters. To reset, press [1].
This SP does not reset the jam history counters: SP7-507, SP7-508.
MF Error Counter Japan Only 7826
Displays the number of counts requested of the card/key counter.
001 Error Total
A request for the count total failed at power on. This error will
occur if the device is installed but disconnected.
002 Error Staple
The request for a staple count failed at power on. This error will
occur if the device is installed but disconnected.
MF Error Counter Clear 7827
Press Execute to reset to 0 the values of SP7826. Japan Only
Self-Diagnostic Report Details 7832
Push [#] to display a list of error codes. Nothing is displayed if no errors have
occurred.
Total Memory Size 7836
Displays the contents of the memory on the controller board.
7901 Assert Info. . DFU
001 Filename
002 Line No.
003 Value
Used for debugging.
Engine Debug Log Switch DFU 7999
This SP sets the debug log switch for one of the settings listed below.
[0~100/0/1]
00 Rapi Commands 10 Toner Supply Motor
01 Queue Check 11 Semiphore
02 Plotter Queue 12 Registration REP
03 Scanner Queue 13 Exit REP
04 Block I/F 14 Transfer SC
05 IPU I/F 15 Drum Charge SC
06 ASAP I/F*
1
16 Charge Grid SC
07 Task 17 Development Bias SC
08 Memory Pool 18 LCT (B832) Tray Lift
09 Watchdog Cycle 19 Serial Signal Send/Receive
*
1
: Finisher, ADF, MCU
To Next Page
Loading...
