Ruckus Wireless Virtual SmartZone - Page 114

• External Antenna (5GHz): To enable the external 5GHz antenna on the AP model, select
the Enable external antenna with [x] dBi (0-90) check box, and then a value for the dBi.
• LLDP: To enable the AP model to advertise its identity and capabilities on the local network
via LLDP, select the Enable Link Layer Discovery Protocol check box. For a list of
attributes that APs advertise using LLDP, see Supported LLDP Attributes on page 50.
• LLDP Advertise Interval (1-300 seconds): Set the interval (in seconds) at which the AP
model will send out LLDP information. The default value is 30 seconds.
• LLDP Hold Time (60-1200 seconds): Set the length of time (in seconds) that a receiving
device will hold the LLDP information sent by the selected AP model before discarding it.
The default value is 120 seconds.
• LLDP Management IP TLV: To include the management IP address TLV in the LLDP
information that the AP model sends out, select Enable check box.
• Port Settings: For information on how to configure the port settings, see Configuring the
Port Settings of a Particular AP Model on page 51.
7. Continue to Step 3: Configure the AAA Servers of the Zone Template.
Step 3: Configure the AAA Servers of the Zone Template
Follow these steps to configure the AAA servers that the zone template will use.
1. Click Configuration > AP Zones.
2. On the sidebar, click Zone Templates.
The Zone Templates page appears.
3. Click the name of the zone template for which you want to configure an AAA server.
4. On the sidebar, click AAA.
5. Click Create New.
The form for creating a new RADIUS server appears.
6. Configure General Options.
• Name: Type a name for the AAA server that you are adding.
• Type: Select the type of AAA server that you have on the network. Options include:
• RADIUS
• RADIUS Accounting
• Active Directory
• LDAP
• Backup RADIUS: Select the Enable backup RADIUS server check box if a secondary
RADIUS server exists on the network. Configure the settings in Step 8.
7. In the Primary Server section, configure the settings of the primary RADIUS server.
• IP Address: Type the IP address of the AAA server.
• Port: Type the port number of the AAA server. The default RADIUS server port number is
1812 and the default RADIUS Accounting server port number is 1813.
• Shared Secret: Type the AAA shared secret.
• Confirm Secret: Retype the shared secret to confirm.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
114
Managing Global Configuration, AP Tunnel Profiles, Templates, and AP Registration Rules
Working with Zone Templates